Do You Know How to Jump Start a Car?
Be ready for a dead car battery by reviewing these simple steps.
Keep in mind that low temperatures can lead to sluggish batteries, so your chances of experiencing a dead car battery will be increased. If you haven’t already, now is the time to make sure you are equipped with a reliable set of jumper cables in your car, you will also need to know how to use them safely.
Prepare for a jump start emergency.
Once you have purchased your jumper cables and have them stowed in your vehicle, take some time to review these steps so you will be prepared to use them. Though it is not difficult to jump start a car, it can be dangerous if not done correctly. Since jumper cables transmit electrical current from one car to another, it can be dangerous if not done correctly. It is necessary to take precautions to prevent dangerous electric shocks.
Prepare for the Jump Start:
- Park the running car so the cars face each other, about one to two feet apart. Make sure that the cars are not in contact with each other.
- Set the parking brakes on both cars. Turn off both cars and take out the keys.
- Lay out the jumper cables on the ground, making sure the clamps do not touch each other.
- Open both car hoods and locate the batteries and battery terminals. (See your owner’s manual for details). The two terminals on each battery are usually covered in red or black, with a + or – sign on top. Identify which is positive, and which is negative, as this will be crucial to the success of your jump.
- Dirty or corroded battery terminals should be cleaned off with a rag or wire brush.
Attach the Jumper Cables to the Car:
- Attach the red, positive cable clamp to the positive (+) battery terminal of the dead battery. Make sure you have a solid connection to the battery terminal.
- Attach the red, positive cable clamp on the other side of the jumper cables to the working battery’s positive (+) battery terminal
- Connect the black, negative cable clamp to the working battery’s negative (-) battery terminal. In the vehicle with the dead battery, attach that clamp to a metal part of the car that is unpainted, as far from the battery as the cable will reach. This will ground the circuit and help prevent sparking.
- Once you have one end of the jumper cables connected to a car, it is critical that the other end of the cables do not touch the metal clamps to anything other than the specified components on the other car. Make sure that none of the cables are in contact with moving engine parts before starting the engine.
Perform the Jump Start:
- Start the engine of the car with the working battery.
- Allow the engine to run for several minutes. The time required for a successful jump may vary depending on the age and condition of the battery.
- Attempt to start the car with the dead battery. If unsuccessful, allow the working car to charge the battery a little longer and try again.
- As soon as the disabled car is running again, you can disconnect the jumper cables, starting with the black, negative cable clamps. Never allow the clamps to come in contact with each other while any part of the cables is still attached to a vehicle.
- Taking the charged car for a short drive lets the battery build up a charge so the battery doesn’t die again once you turn off the car.